V8 Bike Riders Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
3,429 Posts
Discussion Starter · #1 ·
I just couldn't stand it anymore! Temp hit a balmy 42 degrees today so I took the baby stroker out for the first time since the steering neck replacement, new water pump, Holley Red fuel pump, 160 thermostat, PC680 battery and the pullback risers and new wiring harness...all went perfectly.
First of all, I have to thank Don Blixt for suggesting the risers for those of challenged arm length. They make a huge difference in comfort keeping your arms in a much more natural position. The 160 thermostat without any holes drilled works fine keeping it at just that temp despite the cold. Before, I would never see the high side of 150 in this weather.
My biggest fear after the factory neck install was the dreaded high speed wobble but she tracked dead straight at 100 mph.
Also no leaks and over the winter I forgot what a blast hitting the secondaries was. :D ...Joe
 

· Registered
Joined
·
85 Posts
RISERS

DR Joe
what is the OD on your H BARS ?. on the risers how high are they?
what is the angle or set back? I got 1in H_BARS and a set of(9.5 w/ 30degree bend at 6in set back is about 2.25in ) RISERS I am looking for a one piece top clamp that is wide enough for the BH . useing the BH bolt pattern. mj
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top